following: System CMOS Checksum BadRun Setup: Phoenix BIOS CMOS Checksum. If you accidentally reinstall the battery backwards it will not harm the CMOS. 07:53 Shai29: Im sure there is, but installing only takes 30 minutes or so so Id try that first 07:53 maybe also check the disk for defects before you start the installation to make sure the image is correct 07:53 (hold shift during boot to enter the cd menu) 07:54 md5sumShai29 1. POST Error Messages Most BIOS versions do an excellent job of displaying POST. Using needle nose pliers, re-install the battery by pulling the negative terminal (flat side) out enough to slide the battery in at a diagonal.You have to tilt it slightly towards the processor then lift it out. Using needle nose pliers remove the battery. Ran recovery disc 3.3 to wipe out ACS for re-deployment into another network and all I get now is CMOS Checksum Bad Press F1 to Run SETUP Press F2 to load.With your finger nail, gently pull back the negative terminal pressing against the flat side of the battery. WHY DO I SEE THE MESSAGE, CMOS CHECKSUM ERROR That message usually shows up when you remove or install a new component such as a CPU or memory module or when.Place the controller on a table, hard drive side down.To replace the battery yourself, follow the instructions below: Before you replace the battery, make sure you inspect the controller to make sure that the metal clip is making contact with the battery, the battery edges are not corroded, and that there is no physical damage to the controller. Additional InformationYou may replace the battery (BR2032 3V Battery) yourself, though National Instruments will not be responsible for any damage to the controller.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |